Oak (Quercus sp) – 35-40 feet tall x 14 inch trunk

Cut down, cut stump as low as possible, dispose of debris.

Front street tree.

REBAR LOCATING – Trees in some sections of Carolina Preserve were planted with steel rebar instead of wooden stakes. I must locate using a metal detector and remove any rebar before stump grinding. It is extremely dangerous to grind a stump without removing rebar first.

FOUND REBAR charged @ $10-$20/piece. Trees typically have 3 pieces, but some have less or none where someone removed it already.

TOTAL (typical): $0-$60 PER TREE

*THERE IS NO CHARGE IF NO REBAR IS FOUND*. Assuming 3 pieces found.

STUMP GRINDING (estimated until after 811 call and inspection work below completed)

I will need to call 811 to confirm utility line locations. Grind entire mound area.

—– [General Stump Grinding Information Below] —– 

811 locates water and sewer to the curb, electrical, gas, and telecom to the house. Water and sewer generally go straight from the curb location to the house. If there is a question about water and sewer location the customer must waive my liability for these lines.

811 does not mark irrigation systems, low voltage wiring (dog invisible fences, lighting, security, etc.) and other underground systems. Per my waiver, I cannot take responsibility for these unless notified as to their existence and location.

OAK GRINDINGS – Remove stump grindings and dispose to allow for replanting in same spot. Replace with soil as needed. I expect 1/2 cubic yard of debris to be removed.

If you are not replanting anything there, the grindings can be left in place.